Product Description
**Milwaukee parts change not only by model# but also by serial number. Milwaukee's site lets you look up your tool's parts diagram. Enter Cat# and Select Service Parts. Also match Serial Number.
Milwaukee Retaining Ring
Model Number: 34-60-0007
The Milwaukee 34-60-0007 is a genuine OEM Retaining Ring for the 2787-20 and 2788-20 M18 FUEL 1-1/2 in. Mag Drills. A retaining ring, also known as a snap ring or circlip, is a spring-steel ring that snaps into a machined groove on a shaft or inside a bore, forming a removable shoulder that locks a bearing, gear, bushing, or shaft in its correct position so it cannot move along its axis. In the magnetic drill's drivetrain and spindle, where the tool pulls heavy annular-cutter loads, that retention keeps the assembly together and correctly located under load. When a retaining ring is sprung open, deformed, or missing, it can no longer hold its component, and parts begin to shift, wear, or work free, often leading to further damage. Fitting the genuine Milwaukee OEM ring restores secure retention with the correct size and spring rate for the groove, where an off-spec ring may not seat in the groove or hold under the drill's loads.
This retaining ring is cataloged for the 2787-20 and 2788-20 M18 FUEL Mag Drills, including the 2787-059 service version, on the Milwaukee service parts list for these tools. Because retaining rings come in many sizes and a tool often uses more than one, confirm against the service parts diagram that 34-60-0007 is the correct ring for the exact location and model you are servicing; note that this mag drill also uses other retaining rings, including 34-60-0003, so match the ring to its position rather than by appearance. It is a single spring-steel ring installed into its groove with retaining ring pliers. Because Milwaukee specifies service parts by serial number as well as catalog number, verify your catalog and serial number against the official Milwaukee service parts diagram before ordering, since running production changes can alter part compatibility within the same catalog number.
Features
- Genuine Milwaukee OEM retaining ring
- For the 2787-20 and 2788-20 M18 FUEL mag drills (and 2787-059)
- A spring-steel snap ring (circlip) that snaps into a machined groove
- Locks a bearing, gear, bushing, or shaft in its correct axial position
- Keeps the drivetrain and spindle located under heavy drilling loads
- Restores secure retention with the correct size and spring rate
- Replace if the ring is sprung, deformed, or missing
- The mag drill uses more than one ring size; verify the position by diagram
- Not the same as 34-60-0003 used elsewhere on this drill
- Sold individually
Specifications
- Manufacturer: Milwaukee Tool
- Part Number: 34-60-0007
- Official Description: Retaining Ring
- Component Type: Spring-steel retaining ring (snap ring / circlip)
- Primary Fitment: Milwaukee 2787-20 and 2788-20 M18 FUEL Mag Drills (and 2787-059)
- Also Referenced On: Retaining rings come in multiple sizes and locations; verify by serial number and the service parts diagram using Milwaukee's online parts lookup
- Parts Diagram Position: Verify figure on the Milwaukee service parts diagram for your model and serial
- Quantity: Sold individually (1 ring)
- Part Type: Genuine Milwaukee OEM Replacement Part
Includes
- (1) Retaining Ring
Confirm by serial number and the service parts diagram that this is the correct ring for your tool and location before ordering, since this mag drill uses more than one retaining ring. Use Milwaukee's online parts lookup.
