Product Description
**Milwaukee parts change not only by model# but also by serial number. To look up your tools parts break down on Milwaukee's website please click here:
Milwaukee Carbon Brush and Spring
Model Number: 22-18-0910
The Milwaukee 22-18-0910 is a genuine OEM Carbon Brush and Spring assembly for Milwaukee brushed electric power tools. It is a single carbon brush with its lead wire and spring attached, and its job is to conduct electrical current from the tool's stationary power circuit to the rotating armature as the motor runs, with the spring holding the brush in contact against the commutator. Carbon brushes are a normal wear item: they ride against the spinning commutator and slowly wear down, and worn brushes are one of the most common causes of a tool that runs weakly, cuts out intermittently, sparks excessively, or stops running. Replacing them restores firm, consistent contact with the commutator. Milwaukee engineers the brush compound, block dimensions, and spring tension specifically for each motor design, and brushes cannot be substituted between different motors, so order by the exact part number for your tool. Milwaukee's brushed motors use two carbon brushes, one on each side of the commutator, and it is recommended to replace both at the same time even if only one is worn.
This carbon brush fits a variety of Milwaukee brushed corded tools, including reciprocating saws such as the Sawzall family, electric drills, and saws, with representative models including the 6507, 6509, 6519, 6527, and 6537 reciprocating saws and the 1001-1, 1007-1, 1107, and 1250 drills, among others. Because a common brush like this is used across many tools, confirm the figure position and application for your specific tool on its service parts diagram. Replacement is typically straightforward: remove the brush cap or retaining screw at the side of the motor housing, remove the old brush and spring, install the new brush and spring, and reinstall the cap, then repeat for the second brush. Because Milwaukee specifies service parts by serial number as well as catalog number, verify your catalog and serial number against the official Milwaukee service parts diagram before ordering, since running production changes can alter part compatibility within the same catalog number.
Features
- Genuine Milwaukee OEM carbon brush and spring assembly
- One carbon brush with lead wire and spring attached
- Conducts current from the stationary circuit to the rotating armature
- Spring holds the brush in contact against the commutator
- Fixes weak, intermittent, sparking, or non-running motors caused by worn brushes
- Correct brush compound, dimensions, and spring tension for the motor
- Fits many Milwaukee brushed tools: reciprocating saws, electric drills, and saws
- Sold individually; the motor uses two (one on each side of the commutator)
- Replace both brushes at the same time even if only one is worn
- Order by exact part number; brushes are not interchangeable between motors
- Easy service: remove the brush cap, swap the brush and spring, reinstall
- Genuine Milwaukee replacement, not a generic aftermarket brush
Specifications
- Manufacturer: Milwaukee Tool
- Part Number: 22-18-0910
- Official Description: Carbon Brush and Spring
- Component Type: Motor carbon brush with lead wire and spring
- Primary Fitment: Many Milwaukee brushed corded tools (reciprocating saws, electric drills, saws); verify by model and serial number
- Also Referenced On: Representative models include the 6507, 6509, 6519, 6527, 6537 saws and 1001-1, 1007-1, 1107, 1250 drills; the application list is broad
- Parts Diagram Position: Commonly Figure 8; confirm on your tool's service parts diagram
- Quantity: Sold individually; two required per motor, replace both
- Part Type: Genuine Milwaukee OEM Replacement Part
Includes
- (1) Carbon Brush with lead wire and spring
The second brush is NOT included; the motor uses two, so order two to replace the set. The brush cap or holder and the tool are also NOT included and are sold separately. Always verify by serial number using Milwaukee's online parts lookup before ordering, and order by the exact part number, since carbon brushes are engineered per motor and are not interchangeable.
